new year new car gta v6 gt

...got two in the garage ...One is destined for the grey atmo with a set of hot cams .Simple enough conversion and the Renix ECU is ready as well

Snap I also have two and I also have a standard GTA ECU that I am hoping to run it from.....do you know if it's possible to run one of these lumps on this ECU?

si21

Yes , I do know whether it is possible

Full set of pistons now ,thanks to Monkey bullocks
Cleaned ,ringed

Stuff back from the machine shop
Big clean done so most of the shite is off .Now ready for precision cleaning


Heads skimmed .

Looking good there sir Coming along at a good pace Mr. C Carbon looks nice and healthy on both heads; are these the heads with the leaking gasket, or off the spare motor?

Off the knocking block with leaky heads .
Second engine supplied cams and crank only .

Nice inclined valves those ... yes I know, shut up faulksie.. it's all in the optics init..

Don't forget to deburr the chamber wall / edge

Yes ! Shat-it !!!

Old smoker Atmo this is tha knows .none of yer fancy lar-de dar 'ttubut lark sethee

lumps'R'us

Waiting on bits to start the build ....all prepped to go .

Finally got the bits back from the grinders ....except they didn't ....guy inspected them closely and said nah she's fine , polish up and std shells mate .
Can put the bottom end back together but waiting on some liner seals before I can pot it up .

nah she's fine...polish up and std shells

did you get that in writing lee

...I should have just charged you for it and said nowt

Will give it the thrice over ,it's a secondhand crank so no ,it is not perfect but I was borderline myself so have taken advice from a place that does it for a living and would make more money if they did grind it .
I will get a third eye on it

[phildini]

i used to work with a bloke who was always saying...nah it be reet...you know what you're doing lee just follow your gut feeling